Impact sound deadening wedi Nonstep Plan

If the floor covering being renovated is slightly uneven, wedi Nonstep Plan is the product you need. The impact sound deadening board is made from recycled rubber material and XPS flakes bound with polyurethane, which is coated with a special flexible mineral sealing slurry.
You can tile straight onto wedi Nonstep Plan once it has been fully reinforced with wedi Tools reinforcement tape. You only need to level out areas which are particularly uneven beforehand (with levelling and ground-compensation compounds). The improvement in impact sound deadening under ceramic floor coverings is 14 dB.

Apply a perimeter isolation strip all around. Unevenness must be levelled out before laying. It can be cut simply using a carpet cutter.

Seal the joints with masking tape to prevent acoustic bridges.

Apply the tile adhesive over the whole surface as a bonding layer. Lay the wedi Tools reinforcement tape into the tile adhesive with an overlap of 5 – 6 cm and bed it in with the trowel. It can then be tiled.